- whatsapp +51955515985
- support@ecuforcetruck.com
- 24/7 Customer Support
Menu
Shop
Account
Subtotal: $0.00
No products in the cart.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6647 PID: SPN: 6780 FMI: 3 Aftertreatment 1 Diesel Particulate Filter Soot Temperature Sensor – Voltage Above Normal or Shorted to High Source. An internal circuit error has been detected by the aftertreatment particulate matter sensor.
Circuit Description
The aftertreatment particulate matter sensor is a smart device and communicates with the engine control module (ECM) via the J1939 data link. The aftertreatment particulate matter sensor performs internal diagnostics and reports malfunctions back to the primary ECM using the J1939 data link. The particulate matter sensor is permanently attached to the particulate matter control module. They are serviced as a single component and can not be replaced individually. The aftertreatment particulate matter sensor is used to measure the soot emissions at the outlet of the aftertreatment system.
Component Location
The aftertreatment particulate matter sensor location can vary depending on engine application. It is usually located in the exhaust system at the outlet of the selective catalytic reduction (SCR) catalyst.
Conditions for Running the Diagnostics
This diagnostic runs continuously when the engine is running.
Conditions for Setting the Fault Codes
An internal circuit error was detected in the aftertreatment particulate sensor assembly
Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or Malfunction Indicator Lamp (MIL) after the diagnostic fails on two consecutive trips.
Conditions for Clearing the Fault Code
1)To validate the repair, start the engine and let it idle for 1 minute.
2)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
3)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
4)For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Possible causes :
1)Malfunctioning aftertreatment particulate matter sensor
Related
Categories Cumminz, ISB6.7 CM2350 (2013-17)Tags 1, 17, 2013, 3, 6647, 6780, Above, Aftertreatment, an, been, by, Circuit, CM2350, Code, Cummins, Detected, Diesel, Error, Fault, Filter, FMI, has, High, Internal, ISB6.7, Matter, Normal, or, Particulate, PID, Sensor, sensor., Shorted, soot, Source, SPN, Temperature, the, to, Voltage
Wiring Diagrams
Component Locators
- Detroit Diesel Switcher Tool + Video Manual
Detroit$12.00
Rated 0 out of 5
- Allison DOC 2021 V2 (1PC)
Allison$67.00
Rated 0 out of 5
- PACCAR Engine Analyzer v1.3.0.6
PACCAR$55.00
Rated 0 out of 5
- premium volvo tech tool update 2.8.150 diagnostic software 1pc
Trucks software$150.00
Rated 0 out of 5
John Deere$200.00
Rated 0 out of 5
- premium volvo tech tool update 2.8.150 diagnostic software 1pc
Trucks software$150.00
Rated 0 out of 5
PF Diagnose$60.00
Rated 0 out of 5
- VOLVO PREMIUM TECH TOOL PTT 2.7.116 + APCI 2021 + devtool ( ONLINE )
Trucks software$80.00
Rated 0 out of 5
- CAT Password Recovery Tool for CAT ecm configuration files WINDOWS 10
CAT$20.00
Rated 0 out of 5
- Volvo PROSIS Offline 2019 Parts Catalog Installation Service
Trucks software$45.00
Rated 0 out of 5
- HINO EPC 2018 TRUCKS / BUSES 2018 EPC PARTS CATALOG
Hino$85.00
Rated 0 out of 5
- Detroit Diesel DDDL CutOut Calculator v0.1+Tutorials
Detroit$15.00
Rated 0 out of 5
- Bendix Acom Pro 2022 v3 ( 1 PC ) BENDIX 2022 V3
Bendix$85.00
Rated 0 out of 5
- Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino$50.00
Rated 0 out of 5
- Cumming Caltem 5.9.1 2022 ( 1 PC )
cummisznn$78.00
Rated 0 out of 5
- Cat Factory Password Generator 1.0 2019 WINDOWS 10
CAT$55.00
Rated 0 out of 5
- Wabco ToolBox plus 13.7.0.1 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software$84.00
Rated 0 out of 5
John Deere$200.00
Rated 0 out of 5
- VOLVO PTT TECH TOOL 2.8.220 2023 Last version 1pc
Trucks software$200.00
Rated 0 out of 5
- CAT CDVR PC Software – Caterpillar Digital Voltage Regulator (CDVR) WINDOWS 10
CAT$45.00
Rated 0 out of 5
Related products
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3232 PID: SPN:3216 FMI:9 Aftertreatment 1 Intake NOx Sensor – Abnormal Update Rate
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3314 PID: SPN:4765 FMI:3 Aftertreatment 1 Diesel Oxidation Catalyst Intake Temperature Sensor Circuit – Voltage Above Normal or Shorted to High Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3313 PID: SPN:4765 FMI:4 Aftertreatment 1 Diesel Oxidation Catalyst Intake Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:324 PID:SID 3 SPN:653 FMI:5 Injector Solenoid Driver Cylinder 3 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3256 PID: SPN:3246 FMI:15 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Least Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3253 PID: SPN:3242 FMI:0 Aftertreatment Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3235 PID: SPN:4363 FMI:0 Aftertreatment SCR Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:332 PID:SID 4 SPN:654 FMI:5 Injector Solenoid Driver Cylinder 4 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3241 PID: SPN:4342 FMI:4 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit – Voltage Below Normal or Shorted to Low Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3312 PID: SPN:3246 FMI:0 Aftertreatment 1 Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Most Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3231 PID: SPN:4360 FMI:16 Aftertreatment SCR Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:325 PID:SID 6 SPN:656 FMI:5 Injector Solenoid Driver Cylinder 6 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3317 PID: SPN:3242 FMI:3 Aftertreatment 1 Diesel Particulate Filter Intake Temperature Sensor Circuit – Voltage Above Normal or Shorted to High Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3251 PID:S326 SPN:4765 FMI:16 Aftertreatment Diesel Oxidation Catalyst Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:331 PID:SID 2 SPN:652 FMI:5 Injector Solenoid Driver Cylinder 2 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- SERVICE MANUAL BOBCAT 773 sms
BOBCAT$45.00
Rated 0 out of 5
- SERVICE MANUAL MACK V-MAC IV (2010 Emissions)
MACK$40.00
Rated 0 out of 5
- SERVICE MANUAL HINO FD.FE.FF.SG 2019
HINO$40.00
Rated 0 out of 5
- MANUAL SERVICE DEUTZ AGROTRON K 90-100-110-120
DEUTZ$34.00
Rated 0 out of 5
- SERVICE MANUAL International Engines MaxxForce DT 9 10 (2007-2009)
INTERNATIONAL ENGINES$30.00
Rated 0 out of 5
Sale!
Allison Transmission – WTEC 2 MD/HD/B SERIES TRANSMISSIONSAllison
$20.00Original price was: $20.00.Current price is: $16.00.Rated 0 out of 5
- MANUAL SERVICE DEUTZ AGROPLUS 60-70-80
DEUTZ$25.00
Rated 0 out of 5
- SERVICE MANUAL DETROIT DD_PLATFORM_WIRING
DETROIT$60.00
Rated 0 out of 5
- SERVICE MANUAL Carrie 40 and 50 X
CARRIE$20.00
Rated 0 out of 5
- Allison 1000 and 2000 Series Gen 4 (2005-11) Service manual
Allison$10.00
Rated 0 out of 5
